LR stock price Philippines

Engine cleaning refers to the important measures to clean and LR stock price Philippinesmaintain the interior of the car engine to ensure the smooth performance of the vehicle and extend the service life of the vehicle. In daily driving, long-term use will cause various dirt and sediment to accumulate inside the engine, which is likely to affect vehicle performance, increase mechanical wear, improve fuel consumption and other problems. Therefore, it is very important to clean and maintain the engine regularly.The importance of engine cleaning: 1. Remove accumulated slag and dirt: The accumulated slag and dirt accumulated in the oil lubrication and water cooling system block the normal operation of the car engine, resulting in insufficient power, difficulty in starting, black smoke, increased noise and other problems. Short-term hardware failures may even scrap the engine. Two. Improve engine efficiency: Regular cleaning of the engine can effectively eliminate the carbon accumulation of the engine fuel system, valves, pistons and other parts, reduce the loss of engine power, and make the engine run in the best state. Engine cleaning technology improves braking efficiency, power output, acceleration performance, suspension operation, steering and braking performance, etc., and improves driving safety. 3. Reduce fuel consumption and exhaust emissions: After the engine is cleaned, the operation of the engine is smoother and the fuel combustion is more adequate, which canReduce vehicle emissions according to the degree to which carbon deposits block the discharge port, and follow the values of environmental protection and energy saving. There are mainly the following ways to clean the engine: 1. Engine internal cleaner: Use a high concentration of engine interior cleaner to clean the dirt and slag accumulated in the engine. Through high-pressure spraying and cycle cleaning, the scale and debris inside the engine are cleaned up. This method can also cover the cleaning of water pumps, oil pumps, bearings, cylinder walls, pistons and oil channels. Some types of engines can use this technology to remove the blockage and damage of recycled materials and exhaust gas treatment devices at the same time. Two. Air system cleaning: This method uses air compressors or professional cleaning equipment to remove fine particles from the air compressor into the engine to destroy the accumulated harmful substances and discharge the sediment inside the engine and clean chemicals together.This method combines initial cleaning and secondary cleaning into one, with high cleaning efficiency and comprehensive cleaning scope. 3. Basic scrubbing and cleaning: This method is the most basic engine cleaning method. For a small amount of oil, you can use a paper towel or a small brush to scrub and clean it up. The time interval for engine cleaning depends on the usage and mileage of the car. Generally speaking, engine cleaning should be carried out according to each maintenance, and the maintenance cycle should be maintained at about 20,000-50,000 kilometers. It should be noted that no matter what method you choose for engine cleaning, it is best to find a professional auto repair shop to operate it. Do not operate by yourself, so as not to cause unnecessary damage to the vehicle. If you do not install car wash equipment that does not meet the required standards, it will cause the accumulation of car wash residues and aggravate the harm. In addition, pay attention to timely replacement.Air filter, change the oil regularly, and follow the maintenance manual with the car to promote a good user experience. In general, engine cleaning is an important step to maintain the performance of the car, maintain the safety of the vehicle and extend the life of the vehicle. By choosing the appropriate cleaning method and cleaning cycle, it can greatly improve engine efficiency, reduce fuel consumption and exhaust emissions, reduce the failure rate, and achieve comfort and stability of driving.

Contact Us
Phone：020-83484686