Walletinvestor digi plus

Engine thermost is Walletinvestor digi plusa device that can help control the engine temperature. It mainly controls the temperature of the engine by adjusting the inflow and outflow of engine cooling water, so as to keep the engine running in the optimal temperature range and extend the service life of the engine. The control of engine temperature is very important. If the engine temperature is too high or too low, it may bring some potential problems. If the temperature is too high, it will cause the engine to overheat, causing cylinder block deformation, cylinder liner deformation, valve stretching and many other problems. At the same time, it will also lead to excessive fuel consumption, unset-standard emissions, and affect driving safety. If the temperature is too low, it will cause the engine to not work normally, difficult to start, slow oil flow, and increased loss, thus shortening the life of the engine.The function of the engine thermostor is to avoid the occurrence of the above problems. It keeps the engine working in an appropriate temperature range by controlling the flow rate of water, adjusting the temperature of the cooling water in the tank and the load of the waterway. At the same time, it can also improve the utilization rate of fuel, reduce emissions, and ensure the stability and reliability of engine performance. The principle of the engine thermoster is very simple. It mainly uses a physical phenomenon called thermal expansion to control the flow and temperature of water. Thermal expansion refers to the phenomenon that the volume of a substance expands when it is heated and the volume shrinks when it is cooled. There is an expansion body in the engine thermoster. When the engine is working, the coolant temperature rises, causing the coolant to expand, increasing the internal pressure of the expander, thus opening the thermoster and allowing the water to enter the engine for cooling. When the temperature of the engineWhen it drops to the set temperature, the pressure inside the expander decreases, the thermosulator is turned off, and the water stops flowing into the engine. The working principle of the engine thermostor seems simple, but in fact, its details need to be strictly controlled. Because the rise or fall of the engine temperature will have a direct impact on the performance and life of the engine. Therefore, the thermostat must respond to temperature changes quickly and stably under normal use. In order to meet this requirement, the engine thermoster needs to have a series of technical indicators. For example, it is necessary to have fast response, accurate and stable temperature control ability; it is necessary to consider the impact of coolant circulation, water temperature and other factors on engine performance; it is also necessary to have high corrosion resistance, high temperature resistance and long durable service life. In response to the above requirements, a variety of materials and processes need to be used to ensure its performance in the design and manufacture of engine thermosters.The thermosulator itself needs to use corrosion-resistant, high-temperature and high-pressure materials, such as stainless steel, aluminum alloy, etc. At the same time, it is also necessary to control the manufacturing accuracy and surface treatment to ensure that the thermoster can operate normally. To sum up, although the engine thermost is only a small part, it plays a role that cannot be ignored in engine control. It helps to control the engine temperature, ensures the stable and long-lasting operation of the engine, and improves the service life of the engine. Therefore, in normal use, it is necessary to carefully maintain the engine thermoster to avoid failure or wear, so as not to have an unnecessary impact on the engine performance.

Contact Us
Phone：020-83484686